Corsa 14172 Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Lüftungshaube Corsa 14172 herunter. Corsa 14172 5 Seiten. Cat-back exhaust system, 2006 chevrolet corvette z06 axle back system with single pro-series 4.0” tips, 2006 chevrolet corvette z06 axle back system with twin pro-series 4.0” tips, 2006 chevrolet corvette z06 xo-pipe

Seite drucken

Factory Exhaust System Removal:

1. Unbolt the rear sway bar brackets from the rear cross member using

an 18mm socket on the top and bottom bolts. A 15mm wrench will be

needed to hold the lower bolt from turning while the nut is removed.

(See Fig. A). Do not remove lower bolt from suspension.

NOTE: All factory nuts and bolts will be reused to install your CORSA

system, do not discard.

2. Pull the sway bar towards the rear of the car to clear the studs and

rotate it down on the end links. This will give the necessary clearance

to remove the stock mufflers. (See Fig. B)

NOTE: Due to a mid-year change by Chevrolet, vehicles delivered later

in the 2006 model year and beyond MAY NOT need to make the cut

mentioned in Step 3. After completing Steps 4-10, the stock system may

be removed in one piece by rotating the rear muffler to gain clearance as

needed; the cut will make removal of the stock system easier, but is not

required.

3. The passenger side pipe needs to be cut to remove the stock system.

Measure 2.75" to the rear from the clamp on the exit end of the factory

H-pipe and mark the pipe at this distance. Using a chain style pipe

cutter, cut the pipe along the mark. (See Fig. C)

4. Loosen both driver and passenger clamps at rear of stock H-pipe using

a 15mm socket. (See Fig. D)

5. Remove both nuts that hold the H-pipe hanger using a 13mm

socket. An extension may be needed to access these nuts. (See

Fig. E)

6. Remove the 4 nuts and bolts attaching the inlet of the factory H-pipe

to the flanges downstream of the catalytic converters using a 15mm

socket. (See Fig. F)

FIG. D

INSTALLATION INSTRUCTIONS / CAT-BACK EXHAUST SYSTEM

2006 Chevrolet Corvette Z06 Axle Back System

With Single Pro-Series 4.0" Tips

2006 Chevrolet Corvette Z06 Axle Back System

With Twin Pro-Series 4.0" Tips

2006 Chevrolet Corvette Z06 XO-Pipe

FIG. E

PART NUMBER 14172

PART NUMBER 14164

PART NUMBER 14173

FIG. A

FIG. B

FIG. C

FIG. F