Corsa 14172 Einbauanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Einbauanleitung für Lüftungshaube Corsa 14172 herunter. Corsa 14172 5 Seiten. Cat-back exhaust system, 2006 chevrolet corvette z06 axle back system with single pro-series 4.0” tips, 2006 chevrolet corvette z06 axle back system with twin pro-series 4.0” tips, 2006 chevrolet corvette z06 xo-pipe

Seite drucken

CORSA Exhaust System Installation:

1. Hand tighten the front of the CORSA XO-pipe (or stock H-pipe if

reusing) to the flanges using the nuts and bolts previously removed.

(See Fig. M)

2. Fully tighten the nuts to the spring loaded hanger bolts after sliding

the bolt threw the hanger hole. (See Fig. N)

Skip Step 3 if reusing stock H-PIPE.

3. Place supplied TORCA clamp over the expanded end of XO-pipe.

Make sure the orientation is correct (See Fig. O).

4. Slide the passenger side axle pipe labeled 16CS4020 into the

expansion. Do not tighten clamp at this time. (See Fig. P)

Repeat on the driver side using axle pipe labeled 16CS4021.

5. Before installing the rear mufflers, cap both vacuum lines in the rear

bumper with the supplied rubber caps.

6. Starting on the driver side, push the rear hangers on the muffler

into the rubber grommets. (See Fig. Q)

7. Place TORCA clamp on inlet side of driver side muffler in the correct

orientation and with the bolt to the outside of the car. Tighten the

clamp so it has a light snug fit on the muffler, just enough to prevent

spinning during assembly. (See Fig. R)

8. Align the muffler inlet with the axle pipe and slide the pipe into the

expanded muffler inlet. (See Fig. S)

9. At this point, the axle pipe is free to rotate and should be adjusted so

it does not come in contact with the frame rail to the outside or the

transmission lines to the inside. After the pipe is centered and free

of obstructions, continue to next step.

FIG. P

INSTALLATION INSTRUCTIONS / CAT-BACK EXHAUST SYSTEM

2006 Chevrolet Corvette Z06 Axle Back System

With Single Pro-Series 4.0" Tips

2006 Chevrolet Corvette Z06 Axle Back System

With Twin Pro-Series 4.0" Tips

2006 Chevrolet Corvette Z06 XO-Pipe

FIG. Q

FIG. R

PART NUMBER 14172

PART NUMBER 14164

PART NUMBER 14173

FIG. M

FIG. N

C L A M P

Position slot

90° off of bolt

Position

clamp at

expanded

FIG. O

FIG. S

end of

tube