Jandy Infinite WaterColors IWC15W100 Installations- und Betriebshandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Controller Jandy Infinite WaterColors IWC15W100 herunter. Jandy Infinite WaterColors IWC15W100 12 Seiten. Nicheless led light
Auch für Jandy Infinite WaterColors IWC15W100: Handbuch (2 seiten), Benutzerhandbuch (16 seiten)
Seite drucken
Jandy
Infinite WaterColors
LED Light Controller
®
™
Figure 5.
Connect Low Voltage Wires
6.
Turn off power at the breaker panel.
7.
RS-485 comes factory wired to the Light
Controller. Connect the low voltage RS-485
communication wires to the Aqualink RS
automation system. First wire red (R) to 1, black
(B) to 2, yellow (Y) to 3, and green (G) to 4 on
the connector, see Figure 6.
Figure 6.
Connect RS-485 Wires
8.
Check all connection points and wiring for secure
connections.
|
Installation & Operation Manual
NOTE: Cover screw ensures bonding to ground, and must be
9.
Figure 7.
10.
11.
3.4
Zodiac Pool Systems LLC, requires that the Infinite
Water Colors LED Light Controller be connected to a
"bonding loop" that includes all electrical equipment in
the system and on the equipment pad. Bonding lugs must
be connected with a solid copper wire not smaller than 8
AWG (6 AWG in Canada). Failure to do so may void the
Zodiac Pool Systems LLC warranty.
To prevent premature failure of the equipment resulting
from stray voltages and voltage differentials, the
Infinite WaterColors LED Light Controller must be
bonded to other equipment which is part of the pool
plumbing system with a solid copper wire not smaller
in diameter than 8 AWG (6 AWG in Canada).
secured in place.
Turn on the breaker to restore power (LED2 will
turn on red and LED1 will start flashing green).
Pool & Spa Lights will be off due to control from
automation, see Figure 7.
LED1 and LED2
Install cover and secure hand tight with the screw
provided.
Turn on the breaker to restore power (LED1 will
turn on).
Bonding
CAUTION
ENGLISH
Page 7