Jandy Infinite WaterColors IWC15W100 Panduan Instalasi dan Pengoperasian - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pengontrol Jandy Infinite WaterColors IWC15W100. Jandy Infinite WaterColors IWC15W100 12 halaman. Nicheless led light
Juga untuk Jandy Infinite WaterColors IWC15W100: Manual (2 halaman), Panduan Pemilik (16 halaman)
Halaman Cetak
Jandy
Infinite WaterColors
LED Light Controller
®
™
Figure 5.
Connect Low Voltage Wires
6.
Turn off power at the breaker panel.
7.
RS-485 comes factory wired to the Light
Controller. Connect the low voltage RS-485
communication wires to the Aqualink RS
automation system. First wire red (R) to 1, black
(B) to 2, yellow (Y) to 3, and green (G) to 4 on
the connector, see Figure 6.
Figure 6.
Connect RS-485 Wires
8.
Check all connection points and wiring for secure
connections.
|
Installation & Operation Manual
NOTE: Cover screw ensures bonding to ground, and must be
9.
Figure 7.
10.
11.
3.4
Zodiac Pool Systems LLC, requires that the Infinite
Water Colors LED Light Controller be connected to a
"bonding loop" that includes all electrical equipment in
the system and on the equipment pad. Bonding lugs must
be connected with a solid copper wire not smaller than 8
AWG (6 AWG in Canada). Failure to do so may void the
Zodiac Pool Systems LLC warranty.
To prevent premature failure of the equipment resulting
from stray voltages and voltage differentials, the
Infinite WaterColors LED Light Controller must be
bonded to other equipment which is part of the pool
plumbing system with a solid copper wire not smaller
in diameter than 8 AWG (6 AWG in Canada).
secured in place.
Turn on the breaker to restore power (LED2 will
turn on red and LED1 will start flashing green).
Pool & Spa Lights will be off due to control from
automation, see Figure 7.
LED1 and LED2
Install cover and secure hand tight with the screw
provided.
Turn on the breaker to restore power (LED1 will
turn on).
Bonding
CAUTION
ENGLISH
Page 7