Gardena 1806 Anleitung zum Betrieb - Seite 8

Blättern Sie online oder laden Sie pdf Anleitung zum Betrieb für Rasen- und Gartengeräte Gardena 1806 herunter. Gardena 1806 20 Seiten.

7.3 Other products which can be connected

Fig. D

Anti-theft protection

With special one-way screw and bracket.

Available from GARDENA Services.

Fig. E

GARDENA Soil Moisture Sensor (Art. No. 1187)

Fig. F

GARDENA Rain Sensor (Art. No. 1189)

Fig. G

GARDENA Automatic Water Distributor (Art. No. 1198)

Before you use your water timer you must:

1. Insert the battery

2. Connect the water timer to the tap

3. Ensure the new battery works properly.

8.1 Inserting the battery (Fig. A)

1. Remove the control unit

pressing the release button

2. Insert the battery in the battery compartment

battery type IEC 6LR61) (Fig. A).

Note : When inserting the battery pay attention to the + / – markings.

3. Reattach the control unit to the housing. The water timer beeps to signal

it is ready to be programmed.

After another 5 seconds a double beep confirms that the current settings

have been accepted (except when Run Time is set to Reset).

Note : the current time is taken to be the starting time.

4. To delete the current settings, turn the knob to Reset. Set the timer as

described under "Setting the Watering Data".

8.2 Connecting to the Tap (Fig. C)

The Water Timer is fitted with a sleeve nut for taps with a

USAS .75-11.5 NH thread.

8.3 Checking the new battery

To check the new battery, turn on the tap and turn the knob on the water

timer to On (valve opens) and then shortly afterwards to Off (valve closes).

If the battery capacity is too low a warning tone which beeps at intervals

will sound.

Note : To ensure that the water does not cause any damage make sure

that the water flow is directed away from the water timer (connect hose,

stand a bucket underneath, etc.).

from the housing of the water timer by

(see Fig. B / C).

(only use a 9 V alkaline