Alien Aircraft Corp Hornet K-107 Montageanleitung Handbuch - Seite 13
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Spielzeug Alien Aircraft Corp Hornet K-107 herunter. Alien Aircraft Corp Hornet K-107 17 Seiten.
Seite drucken
Covering:
47...Sand all parts smooth with 400 grit sandpaper. Cover the model with a light weight iron on covering material.
Note: After the model is covered you must check the tail surfaces and wings for warps or twists. If there are any
they can be removed by twisting the parts straight and heating the covering.
Final Assembly:
48...Cut the covering away from the stabilizer in the area that makes
contact with the fuselage. Cut the covering away from the stabilizer
slot in the fuselage.
49...Place the stabilizer into position in the fuselage. Make sure that
it is straight and square and then glue it into position.
50...Attach the elevators with the hinges and glue in place.
51...Carefully cut the covering away from areas on the fuselage that
will make contact with the fins. Place the fins into position and make
sure that they are straight and square. Glue the fins into position.
Attach the rudder with the hinges and glue in place.
52...Insert the pushrod housings into the exit slots in the back of the
fuselage. They should extend out about 2 1/2" from the fuselage top.
The front ends should pass thru the slot in former F-6. Glue the hous-
ings to the rear exits. Do not glue the front ends to the former at this
time.
Page 13