Alien Aircraft Corp Hornet K-107 Instrukcja montażu - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka Alien Aircraft Corp Hornet K-107. Alien Aircraft Corp Hornet K-107 17 stron.

Covering:

47...Sand all parts smooth with 400 grit sandpaper. Cover the model with a light weight iron on covering material.

Note: After the model is covered you must check the tail surfaces and wings for warps or twists. If there are any

they can be removed by twisting the parts straight and heating the covering.

Final Assembly:

48...Cut the covering away from the stabilizer in the area that makes

contact with the fuselage. Cut the covering away from the stabilizer

slot in the fuselage.

49...Place the stabilizer into position in the fuselage. Make sure that

it is straight and square and then glue it into position.

50...Attach the elevators with the hinges and glue in place.

51...Carefully cut the covering away from areas on the fuselage that

will make contact with the fins. Place the fins into position and make

sure that they are straight and square. Glue the fins into position.

Attach the rudder with the hinges and glue in place.

52...Insert the pushrod housings into the exit slots in the back of the

fuselage. They should extend out about 2 1/2" from the fuselage top.

The front ends should pass thru the slot in former F-6. Glue the hous-

ings to the rear exits. Do not glue the front ends to the former at this

time.

Page 13