ALIEN WELD XM IGBT Series Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schweißen System ALIEN WELD XM IGBT Series herunter. ALIEN WELD XM IGBT Series 18 Seiten.

4.1. Input wire connection

Each welder is equipped with connection box, connect the power line with the power source 220V.

4.2. Output wire connection

Connect the gas bottle (equipped with the CO2 flow gauge) and the gas inlet with gas tube.

4.2.1 Connect the terminal of the earth clamp with the negative output, another side is clamped on the workpiece

4.2.2 Connect the MIG torch with the output terminal on the wire feeding machine, insert the welding wire through the

MIG torch manually.

4.2.3 Connect the wire feeding machine input cable with the positive terminal of power source. The control cable of wire

feeding machine should be connected with the control connector of power source.

4.3. Welding wire reel installation

4.3.1 Install the wire reel on the holder of wire feeding machine, the hole of wire reel should align with fixed pin on the

holder.

4.3.2 Choose different wire feeding groove according to the wire dimension. (Note: aluminum welding chooses U-shape

groove, other welding wire choose the V-shape groove

4.3.3 Loose the nut of wire pressing roller, thread the welding wire from the spool through the input guide tube, through

the roller groove and into the outlet guide tube. Note: adjust the wire pressing roller and impact the wire, to make sure

the wire will not slide. Avoid the wire deformation due to the oversize pressure

4.3.4 release the wire by rotating the wire reel anticlockwise. In order to avoid wire loose, the new wire reel will fix the

top of wire on the edge of wire reel. Please cut off this top of wire.

4.3.5 choose different wire feeding groove position according to the wire diameter.

4.3.6 Press "wire check" button to lead out the wire.

4. INSTALLATION AND STRUCTURE