ALIEN WELD XM IGBT Series 소유자 매뉴얼 - 페이지 6
{카테고리_이름} ALIEN WELD XM IGBT Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIEN WELD XM IGBT Series 18 페이지.
4.1. Input wire connection
Each welder is equipped with connection box, connect the power line with the power source 220V.
4.2. Output wire connection
Connect the gas bottle (equipped with the CO2 flow gauge) and the gas inlet with gas tube.
4.2.1 Connect the terminal of the earth clamp with the negative output, another side is clamped on the workpiece
4.2.2 Connect the MIG torch with the output terminal on the wire feeding machine, insert the welding wire through the
MIG torch manually.
4.2.3 Connect the wire feeding machine input cable with the positive terminal of power source. The control cable of wire
feeding machine should be connected with the control connector of power source.
4.3. Welding wire reel installation
4.3.1 Install the wire reel on the holder of wire feeding machine, the hole of wire reel should align with fixed pin on the
holder.
4.3.2 Choose different wire feeding groove according to the wire dimension. (Note: aluminum welding chooses U-shape
groove, other welding wire choose the V-shape groove
4.3.3 Loose the nut of wire pressing roller, thread the welding wire from the spool through the input guide tube, through
the roller groove and into the outlet guide tube. Note: adjust the wire pressing roller and impact the wire, to make sure
the wire will not slide. Avoid the wire deformation due to the oversize pressure
4.3.4 release the wire by rotating the wire reel anticlockwise. In order to avoid wire loose, the new wire reel will fix the
top of wire on the edge of wire reel. Please cut off this top of wire.
4.3.5 choose different wire feeding groove position according to the wire diameter.
4.3.6 Press "wire check" button to lead out the wire.
4. INSTALLATION AND STRUCTURE
6