a&p instruments 2001 Series Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Prüfgeräte a&p instruments 2001 Series herunter. a&p instruments 2001 Series 10 Seiten.

Seite drucken

CAL



Stb



Uhr,

Datum,

Monat, Jahr



Config



0,000 g

Meaning of the results:

„FEUCHTE" (HU): moisture content in % of the sample weight.

„FESTSTOFF" (dM): dry matter (solids) in % of the sample weight

„ATRO" (AO): moisture relative to the solids, e.g. 50 % moisture and 50 % solids

mean 100 % ATRO, a German abbreviation used in the chipboard industry.

„PER 1000" (PM): g solids per 1000 g sample weight, e.g. 15 % solids mean 150

PM, a value which is used in German waste water plants.

) Automatic function (Konsta Stop) parameters:

"GAB" is the weight loss in mg, possible are 4; 8; 16; 32 mg. This parameter

depends mostly on the sample weight. For an accuracy of measurement of approx.

0,1 % this parameter has to be set correctly. E.g. a sample weight of approx. 4 – 8 g

needs a setting to 4 mg, because 4 mg is 0,1 % of 4 g.

Sample weight

4 – 8 g

8 – 16 g

16 – 32 g

over 32 g

"AIn" is the reading interval in seconds. This parameter depends on how fast (or

slow) the sample material will loose it's weight during the drying process. For

materials with a faster weight loss the parameter has to be set to small value (4 or 8

sec). Please make some tries to find out the best value for this parameter. The goal

should be, that the sample should dry as fast as possible, but it should dry also

completely.

"Abn" is the time delay after which the automatic function will start to ask the balance

for the weight loss. This parameter should be set to a higher value than 1 minute

(standard), if the sample has to be dried with very low temperature and therefore the

weight loss will start after a longer period than 1 minute.

1 (very calm), 2, 3,

4 (turbulent)

Standard Settings are underlined and bold

Calibrating the balance

Stability of the balance

Set time and date

Settings can be printed by the

„Change"button

Recommended setting

4 mg

8 mg

16 mg

32 mg