Garmin G3000 Anleitung Handbuch - Seite 13
Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Avionik-Display Garmin G3000 herunter. Garmin G3000 18 Seiten. Swapping gsa80 roll & gsa80 yaw servo on citation cj3+
Section 2 Software and Configuration Loading
This section will provide the steps necessary to target load the software and configuration into
GSA 80 Roll & GSA 80 Yaw Servos after swapping.
• GSA 80 (Roll & Yaw Servos)
1) Activate the cursor by pushing down on the FMS knob.
2) Rotate the small knob to drop the menu down, and highlight '525B Base
Configuration' in the GROUP field.
3) Press the Enter key.
4) Rotate the small knob to drop the menu down, and highlight 'Cessna Model 525B
Base Configuration' in the ITEM field.
5) Press the Enter key.
6) Select the CLR ALL softkey at the bottom of the display.
7) Using the FMS knob, highlight the following, press Enter for each, which will place
a check mark in each box:
GSA80 ROLL Software
GSA80 YAW Software
ROLL GAINS Software
YAW GAINS Software
8) Select the LOAD softkey at the bottom of the display.
9) Acknowledge when 'Upload and Crossfill Complete' is displayed by pressing the
Enter key.
10) Push the UPDT CFG softkey to update the system configuration files.
11) Select YES, and press the Enter key.
12) Acknowledge when 'Update Config Complete' is displayed by pressing the Enter
key.
13) Turn aircraft power off, and remove the 010-01293-10 software loader card
from PFD 1.
Version 1.0
REFERENCE ONLY
REFERENCE ONLY
13