Garmin G3000 Manual de instrucciones - Página 13

Navegue en línea o descargue pdf Manual de instrucciones para Pantalla de aviónica Garmin G3000. Garmin G3000 18 páginas. Swapping gsa80 roll & gsa80 yaw servo on citation cj3+

Imprimir página

Section 2 Software and Configuration Loading

This section will provide the steps necessary to target load the software and configuration into

GSA 80 Roll & GSA 80 Yaw Servos after swapping.

• GSA 80 (Roll & Yaw Servos)

1) Activate the cursor by pushing down on the FMS knob.

2) Rotate the small knob to drop the menu down, and highlight '525B Base

Configuration' in the GROUP field.

3) Press the Enter key.

4) Rotate the small knob to drop the menu down, and highlight 'Cessna Model 525B

Base Configuration' in the ITEM field.

5) Press the Enter key.

6) Select the CLR ALL softkey at the bottom of the display.

7) Using the FMS knob, highlight the following, press Enter for each, which will place

a check mark in each box:

 GSA80 ROLL Software

 GSA80 YAW Software

 ROLL GAINS Software

 YAW GAINS Software

8) Select the LOAD softkey at the bottom of the display.

9) Acknowledge when 'Upload and Crossfill Complete' is displayed by pressing the

Enter key.

10) Push the UPDT CFG softkey to update the system configuration files.

11) Select YES, and press the Enter key.

12) Acknowledge when 'Update Config Complete' is displayed by pressing the Enter

key.

13) Turn aircraft power off, and remove the 010-01293-10 software loader card

from PFD 1.

Version 1.0

REFERENCE ONLY