AEG 88101 Service-Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Service-Handbuch für Kochfeld AEG 88101 herunter. AEG 88101 22 Seiten. Induction hobs

Seite drucken

2.3 Alarm message "E"

When the appliance is switched on, "E" / „xx" Alarm Number is displayed in the timer display. With

Frontline the display of the front zone indicates the error number when switching on. The affected

zones are subsequently displayed with an "E" in the cooking phase display and are thereby disabled.

The other zones can still be used.

example (left touch control / right indication in the cooking zone):

1) Display alarm number after switching on for 10 sec.

2) 2 zones are disabled.

Alarm

Display in

the

Symptom

Cooking

Hob Timer

Alarm display in the

"E0"

Touch Control

display.

"E3"

"E4"

DGS-TDS

21.04.08

Possible Alarm

Cause

Incorrect configuration on

the Filterboard.

Under voltage or over

voltage, is only displayed

for 10 sec. after voltage

has been applied.

Coil temperature sensor

defect or not correctly

connected.

Alarm number

Alarm Remedying

Disconnect cooking hob from mains,

wait 10 sec and reconnect the mains

supply.

Should alarm still be displayed,

replace filterboard..

1) Disconnect cooking hobs from the

mains, wait 10 sec. and reconnect the

mains.

2) Should alarm still be displayed,

test L1 against N (4),

test L2 against N (5) at the mains

(1)

connection

3) If OK, see

See Chapter 3 Testing Power

Component

(5)

Inspecting the contacts on the

power component.

Is the connector inserted?

2) The resistance at room

temperature (25°C) amounts to 1000

Ohm. This corresponds to approx. 3.3

Ohm per +1°C deviation.

If not in this range, replace affected

coil including temperature sensor.

3) Should above not succeed, replace

power component concerned.

599 519 523 EN