AEG 88101 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Варочная панель AEG 88101. AEG 88101 22 страницы. Induction hobs
Печатать страницу
2.3 Alarm message "E"
When the appliance is switched on, "E" / „xx" Alarm Number is displayed in the timer display. With
Frontline the display of the front zone indicates the error number when switching on. The affected
zones are subsequently displayed with an "E" in the cooking phase display and are thereby disabled.
The other zones can still be used.
example (left touch control / right indication in the cooking zone):
1) Display alarm number after switching on for 10 sec.
2) 2 zones are disabled.
Alarm
Display in
the
Symptom
Cooking
Hob Timer
Alarm display in the
"E0"
Touch Control
display.
"E3"
"E4"
DGS-TDS
21.04.08
6
E
5
0
E
Possible Alarm
Cause
Incorrect configuration on
the Filterboard.
Under voltage or over
voltage, is only displayed
for 10 sec. after voltage
has been applied.
Coil temperature sensor
defect or not correctly
connected.
Alarm number
E
0
Alarm Remedying
Disconnect cooking hob from mains,
wait 10 sec and reconnect the mains
supply.
Should alarm still be displayed,
replace filterboard..
1) Disconnect cooking hobs from the
mains, wait 10 sec. and reconnect the
mains.
2) Should alarm still be displayed,
test L1 against N (4),
test L2 against N (5) at the mains
(1)
connection
3) If OK, see
See Chapter 3 Testing Power
Component
(5)
1)
Inspecting the contacts on the
power component.
Is the connector inserted?
2) The resistance at room
temperature (25°C) amounts to 1000
Ohm. This corresponds to approx. 3.3
Ohm per +1°C deviation.
If not in this range, replace affected
coil including temperature sensor.
3) Should above not succeed, replace
power component concerned.
599 519 523 EN
.