Brother Stampcreator PRO SC2000USB Kurzreferenz - Seite 26
Blättern Sie online oder laden Sie pdf Kurzreferenz für Etikettenhersteller Brother Stampcreator PRO SC2000USB herunter. Brother Stampcreator PRO SC2000USB 36 Seiten.
Seite drucken
f Remove the cap from a stamp, insert the stamp between the doors so
that the teeth in the centre of the doors fit into the notches in the centre
of the stamp and so that the stamp surface lies flat on the printed draft
sheet, and then slowly close the doors.
☞ Do not use a stamp that has the protective film covering removed
from the stamp surface or that has been assembled with the skirt
and grip.
Before inserting the stamp, be sure that there is no dust on the
protective film covering its surface.
Be sure that the stamp is at the same temperature as the
SC-2000USB, otherwise the stamp may not be engraved correctly.
Be careful not to break the ink bag inside the stamp.
g Close the stamp compartment cover so that it locks and causes the xenon lamp to flash. The message "REMOVE
STAMP !" appears on the display.
☞ Be careful not to pinch your fingers with the compartment cover while closing it.
Do not open the stamp compartment cover until after the flash has fired.
h Open the stamp compartment cover and the doors, remove the stamp,
and then slowly peel the protective film off the surface of the stamp.
The printed draft sheet is fed out from the exit slot on the top right end
of the SC-2000USB.
Arrow
Lever
Stamp
23