Brother Stampcreator PRO SC2000USB Riferimento rapido - Pagina 26

Sfoglia online o scarica il pdf Riferimento rapido per Etichettatrice Brother Stampcreator PRO SC2000USB. Brother Stampcreator PRO SC2000USB 36.

f Remove the cap from a stamp, insert the stamp between the doors so

that the teeth in the centre of the doors fit into the notches in the centre

of the stamp and so that the stamp surface lies flat on the printed draft

sheet, and then slowly close the doors.

☞ Do not use a stamp that has the protective film covering removed

from the stamp surface or that has been assembled with the skirt

and grip.

Before inserting the stamp, be sure that there is no dust on the

protective film covering its surface.

Be sure that the stamp is at the same temperature as the

SC-2000USB, otherwise the stamp may not be engraved correctly.

Be careful not to break the ink bag inside the stamp.

g Close the stamp compartment cover so that it locks and causes the xenon lamp to flash. The message "REMOVE

STAMP !" appears on the display.

☞ Be careful not to pinch your fingers with the compartment cover while closing it.

Do not open the stamp compartment cover until after the flash has fired.

h Open the stamp compartment cover and the doors, remove the stamp,

and then slowly peel the protective film off the surface of the stamp.

The printed draft sheet is fed out from the exit slot on the top right end

of the SC-2000USB.

Arrow

Lever

Stamp