Brother Stampcreator PRO SC2000USB Kurzreferenz - Seite 33

Blättern Sie online oder laden Sie pdf Kurzreferenz für Etikettenhersteller Brother Stampcreator PRO SC2000USB herunter. Brother Stampcreator PRO SC2000USB 36 Seiten.

Brother Stampcreator PRO SC2000USB Kurzreferenz
• The xenon lamp flashed, but the desired stamp could
not be engraved.
• The stamp was engraved too much.
• The stamp was not engraved well enough.
• Half of the stamp was either engraved too much or not
enough.
• The stamp is attached to the printed draft sheet.
• The draft sheet is not fed out after the stamp is
engraved (the xenon lamp flashed).
• The draft sheet or ID label sheet is jammed within the
unit or the error messages "REMOVE LABEL 1",
"REMOVE LABEL 2", or "REMOVE LABEL 3" appears
on the display.
30
PROBLEM
SOLUTION
• Check that the cap was removed from the stamp
before it was inserted.
• Check that there is no dust on the protective film
covering the surface of the stamp.
• Check that the clear plastic surface of the xenon lamp
unit is not dirty.
• Check that the printed draft sheet stopped over the
xenon lamp unit before trying to engrave a stamp.
• The lines in the layout are too thin, the text is too
small, or the fill pattern is too detailed.
• Replace the xenon lamp unit as explained on page 28.
• The layout is too detailed.
• Check that the clear plastic surface of the xenon lamp
unit is not dirty.
• Replace the xenon lamp unit as explained on page 28.
• Check that the stamp is inserted so that its surface lies
flat on the printed draft sheet before engraving it.
• Check that the protective film was not peeled off the
surface of the stamp before it was engraved.
• Check that the draft sheet feeds out automatically the
next time that an ID label sheet or another draft sheet
is printed.
• Turn off the SC-2000USB, then remove the jammed
draft sheet or ID label sheet as explained on page 31.