- ページ 33

ラベルメーカー Brother Stampcreator PRO SC2000USBのPDF クイック・リファレンスをオンラインで閲覧またはダウンロードできます。Brother Stampcreator PRO SC2000USB 36 ページ。

• The xenon lamp flashed, but the desired stamp could

not be engraved.

• The stamp was engraved too much.

• The stamp was not engraved well enough.

• Half of the stamp was either engraved too much or not

enough.

• The stamp is attached to the printed draft sheet.

• The draft sheet is not fed out after the stamp is

engraved (the xenon lamp flashed).

• The draft sheet or ID label sheet is jammed within the

unit or the error messages "REMOVE LABEL 1",

"REMOVE LABEL 2", or "REMOVE LABEL 3" appears

on the display.

PROBLEM

SOLUTION

• Check that the cap was removed from the stamp

before it was inserted.

• Check that there is no dust on the protective film

covering the surface of the stamp.

• Check that the clear plastic surface of the xenon lamp

unit is not dirty.

• Check that the printed draft sheet stopped over the

xenon lamp unit before trying to engrave a stamp.

• The lines in the layout are too thin, the text is too

small, or the fill pattern is too detailed.

• Replace the xenon lamp unit as explained on page 28.

• The layout is too detailed.

• Check that the clear plastic surface of the xenon lamp

unit is not dirty.

• Replace the xenon lamp unit as explained on page 28.

• Check that the stamp is inserted so that its surface lies

flat on the printed draft sheet before engraving it.

• Check that the protective film was not peeled off the

surface of the stamp before it was engraved.

• Check that the draft sheet feeds out automatically the

next time that an ID label sheet or another draft sheet

is printed.

• Turn off the SC-2000USB, then remove the jammed

draft sheet or ID label sheet as explained on page 31.