- ページ 35

ラベルメーカー Brother Stampcreator PRO SC2000USBのPDF クイック・リファレンスをオンラインで閲覧またはダウンロードできます。Brother Stampcreator PRO SC2000USB 36 ページ。

Brother Stampcreator PRO SC2000USB クイック・リファレンス
MESSAGE
CLOSE COVER !
CHECK RIBBON !
INSTALL Xe UNIT
REPLACE Xe UNIT
INSERT LABEL !
CHANGE LABEL !
REMOVE LABEL 1
REMOVE LABEL 2
REMOVE LABEL 3
CHANGE STAMP !
RESET STAMP !
I/F ERROR !
CACHE FULL !
SRAM DEFECT !
HEAD ERROR !
Xe UNIT ERROR !
SIZE PCB ERROR!
CHECK TRAY !
CHARGE ERROR !
32

Error Message List

• Close the ink ribbon compartment cover.
• Install the ink ribbon cassette.
• Replace the ink ribbon cassette.
• Install the xenon lamp unit.
• Replace the xenon lamp unit.
• Insert an ID label sheet into the ID label slot.
• Correctly insert the specified draft sheet or ID label sheet into the ID label slot.
• Remove the draft sheet or ID label sheet from the ID label slot or pull out the draft tray
and remove the draft sheet.
• Open the ink ribbon compartment cover, and then remove the draft sheet or ID label
sheet.
• Open the ink ribbon compartment cover, remove the xenon lamp unit, and then
remove the draft sheet or ID label sheet.
• Insert a stamp that is the correct size.
• Re-insert the stamp.
• Check the interface cable connections.
• For Serial connection only, check the COM port setting on the PC.
Display the printer Properties box, and then select the following setting for "Port
Setting" of the COM port.
Bits per second : 115200
Data bits : 8
Parity : None
Stop bits : 1
Flow Control : Hardware
• Contact your service representative.
• Check the interface cable connections.
• Contact your service representative.
• Contact your service representative.
• Contact your service representative.
• Replace the xenon lamp unit.
• Contact your service representative.
• Contact your service representative.
• Load draft sheets into the draft tray, and then insert the draft tray into the draft tray slot.
• Clean the draft sheet rollers using a cleaning sheet.
• Contact your service representative.
• Turn off the machine, and wait for one minute before turning on the machine and
trying to print again.
SOLUTION