■ Temporary error
Indication
U1
A paper feed error occurred.
U2
A multi feed error occurred.
U4
The ADF cover or the pre-imprinter
cover is opened.
U6
The print cartridge is not set.
U8
One of the following error occurred:
1. The document sensors are dirty.
2. The stacker is full.
3. The Brake roller or Separator rollers
are not installed properly.
The following shows the procedure for releasing of each
of the temporary errors.
• "U1" error
1. Remove the jammed documents.
(Refer to the fi-5900C Operator's Guide "6.1
Clearing Document Jams" on the Setup CD-
ROM.)
2. Confirm that the documents meet the paper
specifications for scanning.
(Refer to fi-5900C Operator's Guide "7.2 Doc-
ument Quality" on the Setup CD-ROM.)
• "U2" error
Press the [Send to] button on the Operator Panel.
The documents that were multi fed will be
ejected.
• "U4" error
Close the ADF cover or pre-imprinter cover.
• "U6" error
This is a temporary error related to the Imprinter
option (sold separately). For details, refer to the
"fi-590PRF/ fi-590PRB Operator's Guide, "5
Error Message".
• "U8" error
1. Clean the document sensors
For details refer to fi-5900C Operator's Guide
"4.5 Cleaning the Transport path and the sen-
sors".
2. Verify that the number of sheets ejected to the
stacker is below stacker's capacity, and that
the Pick roller is not set for manual feeding.
3. Verify that the both rollers are installed prop-
erly. For details, refer to fi-5900C Operator's
Guide "5.5 Replacing the Separator Rollers"
and "5.6 Replacing the Brake roller".
3
AP-
Meaning
■ Device alarm (Permanent error)
Indication
E0
Hopper or Stacker error
E2
Optical system error (front)
E3
Optical system error (back)
E4
The motor fuse has blown out.
E5
The lamp fuse has blown out.
E6
Operator panel error
E7
Trouble occurred in the internal memory
(EEPROM).
E8
SCSI fuse has blown out
E9
Image memory error
EA
Imprinter error
Image memory error
Ec
Ed
SCSI interface or USB interface
controller error
EF
Background switching mechanism error
E10
ROM error
E11
Cooling fan error
E12
Heater error
E15
Extended memory error
E16
Option board error
E17
The imprinter fuse has blown out.
E18
Sensor error
E19
LSI error
E1A
Troubles occurred in the communication
inside of the scanner.
When you encounter any alarm, turn off and on the
scanner. If the alarm is still displayed on the Function
Number Display, contact the store where you purchased
the scanner or an authorized FUJITSU scanner service
provider.
Meaning
Seite drucken