Chapter 3
Notes
3.5
Server Startup and Power Supply Control Notes
3.5
Server Startup and Power Supply Control Notes
Before turning the server on, check that the ETERNUS DX/AF storage systems and Fibre Channel switches are
all "Ready". If the server is turned on and they are not "Ready", the server will not be able to recognize the
ETERNUS DX/AF storage systems.
Also, when the ETERNUS DX/AF power supply is being controlled by a connected server, make sure that the
ETERNUS DX/AF does not shut down before the connected servers. Similarly, the Fibre Channel switches must
also be turned off after the connected servers have been shut down. If turned off, data writes from the run-
ning server cannot be saved to the ETERNUS DX/AF storage systems, and already saved data may also be
affected.
3.6
Veritas Volume Manager (VxVM) Notes
Confirm and acquire the ASL required for using the ETERNUS DX/AF storage systems from the following Ver-
•
itas web-site.
https://sort.veritas.com/asl
Refer to
"8.4 Installing the FJspio Package" (page 23)
•
before installing VxVM.
Install Veritas Array Support Library (ASL) after installing VxVM.
•
•
For VxVM 5.1 or later
ASL does not need to be installed.
3.7
Notes for Veritas Volume Manager Dynamic Multipathing
(VxVM DMP)
When using the VxVM DMP function, do not use it with a single path configuration.
3.8
Veritas Cluster Server (VCS) Notes
Veritas Cluster Server should be installed according to the directions given in the documentation provided
with Veritas Cluster Server.
3.9
Multipath Notes
Refer to the "Server Support Matrix" for details of the different combinations of Multipath configurations.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for AIX
and install the FJspio package on the AIX system
14
Copyright 2018 FUJITSU LIMITED
P3AM-3782-23ENZ0
Seite drucken