Indesit DD60C2C(X)UK.1 Handbuch für Installation und Gebrauch - Seite 18
Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Backofen Indesit DD60C2C(X)UK.1 herunter. Indesit DD60C2C(X)UK.1 24 Seiten.
Seite drucken
EN
Care and Cleaning
Main Oven Liners
Top Oven Liners
It should not normally be necessary to clean the
'Stay clean' panels in water. If the user feels it is
desirable to do so, wash them in warm soapy water,
followed by rinsing in clean water. Do not use
enzyme/biological washing powder, harsh
abrasives or oven chemical cleaners of any kind.
Decorative trims:
It is advisable to clean the decorative trims regularly
to prevent any build up of soiling which may detract
from the appearance of the cooker.
The recommended method of cleaning is to wipe
over the trims with a soft cloth wrung out in hot water
or mild non-abrasive cleaner. (If in doubt try the
cleaner on a small area of trim which is not
noticeable in normal use).
Then, after wiping with a cloth wrung out in clear
water, dry with a soft clean cloth.
Never use scouring pads or abrasive cleaners/
powders which may scratch the surface.
Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the
oven chassis, if necessary remove the seal by
carefully unhooking the corner clips.
Take care that the rating label edges are not lifted
during cleaning, and furthermore that the lettering is
not blurred or removed.
Control Panel:
Wipe with a damp cloth and polish with a dry cloth.
Stainless trims:
Regularly wipe with a clean, damp cloth and polish
with a clean dry cloth.
Grill:
Remove the wire grid food support, it is best to
wash these items immediately after use to prevent
stains from being burnt on when used again. Wipe
out the Grill compartment, use a fine steel wool soap
pad to remove stubborn stains from the floor of the
compartment.
Main oven:
1.Glass Door - open the oven door fully. The glass
panel may now be cleaned. Stubborn stains can be
removed by using a fine steel wool soap pad. Do
not use scouring pads, or abrasive powder, which
will scratch the glass. Ensure that the glass panel is
not subjected to any sharp mechanical blows. For
18
- side and rear panels.
- sides
slight soiling the inner glass panel may be cleaned,
while still warm. For removing stubborn stains see
next page.
2.
Remove the rod shelves. Use a fine steel wool
soap pad to remove stubborn stains from the rod
shelves and the floor of the oven. Refer to the
instructions on previous page for cleaning the 'Stay
clean' panels.
Doors
Wipe over the outer door glass panels with a cloth
wrung out in warm soapy water, then after wiping
with a cloth wrung out in clear water, dry with a soft
clean cloth. Ensure that glass doors are not
Ensure that glass doors are not
Ensure that glass doors are not
Ensure that glass doors are not
Ensure that glass doors are not
subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.
subjected to any sharp mechanical blows.
Replacement oven lamp:
WARNING: Ensure that the appliance is switched
off before replacing the lamp to avoid the
possibility of electric shock.
Open the oven door and remove the rod shelves.
Using a suitable cloth to protect the fingers grip the
light glass dome, unscrew anti-clockwise and lift.
Reach into the aperture and unscrew the lamp anti-
clockwise. Fit replacement lamp (25W 300°C rated
SES), refit dome.
Do not use the oven lamp as/for ambient lighting
Wall-mounted splash panel:
A wall-mounted splash panel is available as an
optional extra from our Parts Department (see Key
Contacts, back page).
Care must be taken that rating label edges are not
lifted during cleaning and furthermore that the
lettering is not blurred or removed. For details of
your nearest Service Centre please see the separate
service leaflet. If you have any queries regarding
service or spares, our Parts and Service Division will
be pleased to advise.
See Key Contacts, back page, for details.
Take particular care not to damage the inner
surface of the door inner glass that is coated with
a heat reflective layer.Do not use scouring pads,
or abrasive powder, which will scratch the glass.
Ensure that the glass panel is not subjected to
any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel
wool pad. For slight soiling the inner glass panel may
be cleaned, while still warm, without removing it from
the door. After cleaning, rinse and dry with a soft cloth.