Indesit DD60C2C(X)UK.1 Handbuch für Installation und Gebrauch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Gebrauch für Backofen Indesit DD60C2C(X)UK.1 herunter. Indesit DD60C2C(X)UK.1 24 Seiten.

Seite drucken

Installation

WARNING - THIS APPLIANCE MUST

BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure

that the voltage corresponds with your supply

voltage, this is stated on the rating plate, which is

situated on the outer rear panel.

The model number and serial number are located on

the front of the cooker, as shown on the Feature's

page.

The cooker must be connected by a competent

person such as one who is a, NICEIC registered

contractor to a suitable double-pole control unit with

a minimum rating of 32A and a minimum contact

clearance of 3mm (applicable to newer properties,

older properties where a 30A double pole control unit

and a minimum contact clearance of 3mm is

acceptable).

The double pole control unit should be fitted

adjacent to the cooker, in accordance with IEE

regulations. The control unit must be within 2 metres

of but not directly above the appliance and should

be easily accessible in the event of an emergency.

The power supply cable should conform to B.S.6004

with a conductor size of 6mm2, minimum.

Access to the mains terminals is gained by

removing the rear access cover. The mains cable

must pass through the cable clamp adjacent to the

terminal block. Sufficient cable should be used to

allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away

from any brackets affixed to the rear panel and

is not trapped to the rear wall when pushing the

cooker into position between cabinets.

Levelling

Four skid feet are fitted which can be adjusted up or

down to level the cooker.

For a correct installation of the cooker the following

precautions must be followed:

The height of the cooker can be adjusted by means

of adjustable feet in the plinth (900mm - 920mm).

Adjust the feet by tilting the cooker from the side.

Then install the product into position.

NOTE: This appliance must not be fitted on a

platform.

CAUTION:

CAUTION: Some soft floor coverings may get

CAUTION:

damaged if the cooker is not moved carefully.

Badly leveled device may increase condensation.

NOTE:

NOTE: Ensure oven shelves are level by using a

NOTE:

spirit level on the rod shelves.

This operation must be perfomed

by a qualified technician

Siting the Cooker

The cooker is designed to fit between kitchen

cabinets spaced 600mm apart. The space either

side need only be sufficient to allow withdrawal of

the cooker for servicing and cleaning.

It can be used with cabinets one side or both as well

as in an angled corner setting. It can also be used

freestanding.

Adjacent side walls which project above hob level,

must not be nearer to the cooker than 150mm and

should be protected by heat resistant material. Any

overhanging surface or cooker hood should not be

nearer than 650mm.

Note: This appliance must NOT be fitted on a

platform.

Moving the Cooker

Before moving your cooker, switch off at the cooker

control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable

grip on the underside front edge of the oven roof,

avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding

suppression of radio and television interference.

Note: Take care in moving the cooker as it is

heavy. Take care to ensure that any floor

covering is not damaged.

The appliance must not be installed behind

a decorative door in order to avoid overheating

Metal cover

After installing the power cable, screw the metal cover

150

650

with three screws.

600