Indesit KN6C66A/FR Betriebsanleitung - Seite 13

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Backofen Indesit KN6C66A/FR herunter. Indesit KN6C66A/FR 24 Seiten.

Seite drucken

1. Cooking Modes

Installation

! Please keep this instruction booklet in a safe place

for future reference.. Make sure the booklet remains

with the appliance if it is sold, given away or moved.

! Please read this manual carefully: it contains

important information on installation, operation and

safety.

! The appliance must be installed by a qualified

professional in accordance with the instructions

provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected

from the electricity supply.

Positioning and levelling

! The appliance may be installed alongside any

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall which is in contact with the

back of the appliance is made from a non-

flammable, heat-resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the

studio flat (not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 600 mm

away from them.

• If the cooker is installed underneath a wall cabinet,

there must be a minimum distance of 420 mm

between this cabinet and the top of the hob.

HOOD

600

Min.

mm.

• Any hoods must be installed in accordance with

the instructions listed in the relevant operating

manual.

This distance should

be increased to 700

mm if the wall cabinets

are flammable ( see

figure ).

• Do not position

blinds behind the

cooker or less than 200

mm away from its

sides.

Levelling

If it is necessary to level the

appliance, screw the

adjustable feet into the

positions provided on each

corner of the base of the

cooker ( see figure ).

The legs* fit into the slots on

the underside of the base of

the cooker.

Electrical connection

Fitting the power supply cable

To open the terminal board:

• Insert a screwdriver into the side tabs of the

terminal board cover.

To install the cable, follow the instructions below:

• Loosen the cable clamp screw and the wire

contact screws.

! The jumpers are pre-set at the Factory for 230 V

single-phase connection ( see figure ).

230V ~

H05RR-F 3x4 CEI-UNEL 35363

• To carry out the electrical connections as shown in

the figures, use the two jumpers inside the box

( see figure - labelled "P").

• Pull the cover to

open it.