Indesit RID60G2/UK Betriebsanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Herde Indesit RID60G2/UK herunter. Indesit RID60G2/UK 24 Seiten. Free standing gas cooker

Seite drucken

Installation

SPACE FOR FIXING

The cooker can be close fitted below hotplate level.

This requires a minimum distance of 600mm between

cupboard units of hotplate height.

When installing next to a tall cupboard, partition or wall,

for a minimum distance of 400mm above hotplate level,

allow a side clearance of at least 65mm.

The diagram below illustrates the minimum clearance

between the cooker and adjacent walls, cupboards

etc.

The wall behind the cooker, 50mm below and 450mm

above, and the width of the cooker, must be a non-

combustible material such as ceramic wall tiles.

If the cooker is to be fitted close to a corner on the left

hand side, ensure that there is a clearance of at least

50mm to allow the main oven door to open fully for

when removing oven shelves.

600 mm Min

COOKER HOODS

If a cooker hood is to be installed, refer to the cooker

hood manufacturers' instructions regarding fixing

height.

UNPACKING THE COOKER

Unpack the components from inside the grill and oven.

Check that the following parts are present:

Grill pan and grid

Top oven/grill shelf heat

shield

Pan supports

Enamelled

burner caps (4) Top oven/grill shelf (1)

Aluminium

burner bodies(4) Literature

LEVELLING

Four skid feet are fitted which can be adjusted up or

down to level the cooker.

CONVERSION FOR USE ON BUTANE

(G30) OR PROPANE (G31)

Each burner requires the injector to be replaced and

bypass screws adjusted or replaced as follows:

1. Remove the loose hotplate burner parts.

2. Using a 7mm socket, replace the hotplate injectors

as appropriate (see table on previous page).

3. Re-position the loose burner parts.

4. Remove the enamelled baffle at the front of the grill

(2 screws).

5. Remove the screw on the right hand side of the

burner and gently slide the burner off the injector.

65 mm Min

6. Using a 7mm socket, replace the grill injector as

appropriate (see table on previous page).

7. Re-assemble the burner and baffle.

8. Inside the top oven, remove the central screw se-

curing the burner retainer. Slide the retainer to the

right slightly and lift away.

9. Lift the burner assembly and place on the floor of

the oven to the right of the burner opening.

10. Using a 7mm socket, replace the oven injector as

appropriate (see table on previous page).

11. Re-assemble the oven burner and retainer.

12. Replace the main oven injector following the same

procedure as for the top oven.

13. Carefully pull off the control knobs.

14. Using a narrow flat bladed screwdriver rotate the

bypass screws fully clockwise. The main oven

thermostat bypass screw is located on the body

of the thermostat below the spindle, the top oven

thermostat bypass screw is located on the body of

the thermostat to the right of the spindle and the

hotplate tap bypass screws are located down the

centre of the spindle.

15. Re-assemble the control panel parts.

16. Secure the self-adhesive LPG conversion label over

the gas details on the data badge.

Main oven shelves (2)