2N Lift8 Kurzanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Kurzanleitung für Kontrolleinheit 2N Lift8 herunter. 2N Lift8 17 Seiten. Io module
Auch für 2N Lift8: Kurzanleitung (8 seiten), Kurzanleitung (12 seiten), Kurzanleitung (13 seiten), Kurzanleitung (14 seiten), Kurzanleitung (6 seiten), Kurzanleitung (12 seiten)

Product Introduction

2N® Lift8 Splitter helps extend installations where communications units from multiple shafts are to be interconnected

(communicators can be connected directly to the Central Unit in single-shaft installations). It is connected to the Central Unit via 6

wires (power supply, audio, data). The audio units are connected to the splitter via a two-wire bus. In addition, the splitter contains

a NO / NC contact for the lift blocking function. There can be up to 7 splitters (depending on the count of lift shafts). Each splitter

must be assigned a different address (lift shaft number) to make the system work. The address is set to 2–8 (lift 2–8). Address 1 is

the Central Unit. The splitter connection is serial, i.e. inline. No parallel connection is possible. Parallel connection would make the

Lift8 system unstable. A terminating jumper has to be connected to the last splitter or I/O module (the farthest one from the CU).

Description

Main Bus Connection

Take the push-in terminal board out of the main bus connector and connect the six wires from the Central Unit. Maintain polarity

(power +–, audio + -, data + –), see the splitter cover label, to make the Lift8 system work properly.

1. Main bus power +

2. Main bus power –

Audio Unit – Splitter Bus Connection

Interconnect the splitter and the audio units using a two-wire bus. Maintain polarity again.

Address Setting

Set the splitter address for the given lift using a 10-position switch 0–9.

Set lift 2–8 to 2–8 (e.g. set the switch to position 5 for lift 5).

3. Main bus audio +

4. Main bus audio –

5. Main bus data +

6. Main bus data –

1. Main bus power +

2. Main bus power –