- ページ 2

コントロールユニット 2N Lift8のPDF 簡単なマニュアルをオンラインで閲覧またはダウンロードできます。2N Lift8 17 ページ。 Io module
2N Lift8 にも：簡単なマニュアル (8 ページ), 簡単なマニュアル (12 ページ), 簡単なマニュアル (13 ページ), 簡単なマニュアル (14 ページ), 簡単なマニュアル (6 ページ), 簡単なマニュアル (12 ページ)

Product Introduction

2N® Lift8 Splitter helps extend installations where communications units from multiple shafts are to be interconnected

(communicators can be connected directly to the Central Unit in single-shaft installations). It is connected to the Central Unit via 6

wires (power supply, audio, data). The audio units are connected to the splitter via a two-wire bus. In addition, the splitter contains

a NO / NC contact for the lift blocking function. There can be up to 7 splitters (depending on the count of lift shafts). Each splitter

must be assigned a different address (lift shaft number) to make the system work. The address is set to 2–8 (lift 2–8). Address 1 is

the Central Unit. The splitter connection is serial, i.e. inline. No parallel connection is possible. Parallel connection would make the

Lift8 system unstable. A terminating jumper has to be connected to the last splitter or I/O module (the farthest one from the CU).

Description

Main Bus Connection

Take the push-in terminal board out of the main bus connector and connect the six wires from the Central Unit. Maintain polarity

(power +–, audio + -, data + –), see the splitter cover label, to make the Lift8 system work properly.

1. Main bus power +

2. Main bus power –

Audio Unit – Splitter Bus Connection

Interconnect the splitter and the audio units using a two-wire bus. Maintain polarity again.

Address Setting

Set the splitter address for the given lift using a 10-position switch 0–9.

Set lift 2–8 to 2–8 (e.g. set the switch to position 5 for lift 5).

3. Main bus audio +

4. Main bus audio –

5. Main bus data +

6. Main bus data –

1. Main bus power +

2. Main bus power –