AEG 5708 D Betriebs- und Installationshandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Betriebs- und Installationshandbuch für Lüftungshaube AEG 5708 D herunter. AEG 5708 D 20 Seiten. Electrolux group. cooker hood operating and installation instructions dl 4150, chdl 4150, dl 6250, 570 d, 5708 d
Auch für AEG 5708 D: Betriebs- und Installationsanleitung (20 seiten), Betriebs- und Installationshandbuch (19 seiten), Betriebs- und Installationshandbuch (20 seiten), Betriebs- und Installationsanleitung (20 seiten)

Electrical connection

Safety warnings for the electrician

Before connecting the appliance to the power supply, check that the

voltage indicated on the rating plate corresponds to the mains power

supply available. Appliances fitted with a plug can be connected to

any standard power socket within easy access.

Should it be necessary to provide a fixed connection, the hood must

only be installed by an electrician authorised by the local electricity

board. When installing, an omnipolar disconnector with a distance of

at least 3 mm between contacts must be provided.

Fixed connection of the appliance must only be carried out by an

authorised electrician.

Installation - Fig. 8

Only 5708 D: this model is equipped with two outlet hole. 2 hoses are

therefore necessary for discharging the fumes.

If present, an opening for the easy passage of both hoses must be

made in the top of the wall-unit.

• Drill the base of the wall unit to allow for passage of the hood body.

Fig. 7.

• Drill the top of the wall unit to allow for passage of the exhaust pipe

and the electrical cable. Fig. 7.

• Remove the grease filter (1).

• Remove the grease filter support frame, by pressing the two spring

clamps located at the sides of the frame (2).

• Through the top of the wall unit, insert a pipe with a diameter of

120mm at the connection ring (3).

• Fit the connection ring on the hood exhaust outlet (4) and fasten it

to the exhaust pipe.

• Insert the body of the hood into the hole in the base of the wall unit

(5) – check the position of the exhaust pipe and the electrical cable,

press firmly so that the anchor springs (6) engage above the bottom

of wall unit. Tighten the screws in the anchor springs firmly.

• If necessary the hood can be fastened with four more screws (7).

• Replace the grease filter support frame.

• Replace the grease filter.