AEG 5708 D 운영 및 설치 매뉴얼 - 페이지 13

{카테고리_이름} AEG 5708 D에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 5708 D 20 페이지. Electrolux group. cooker hood operating and installation instructions dl 4150, chdl 4150, dl 6250, 570 d, 5708 d
AEG 5708 D에 대해서도 마찬가지입니다: 작동 및 설치 지침 (20 페이지), 운영 및 설치 매뉴얼 (19 페이지), 운영 및 설치 매뉴얼 (20 페이지), 작동 및 설치 지침 (20 페이지)

페이지 인쇄

Electrical connection

Safety warnings for the electrician

Before connecting the appliance to the power supply, check that the

voltage indicated on the rating plate corresponds to the mains power

supply available. Appliances fitted with a plug can be connected to

any standard power socket within easy access.

Should it be necessary to provide a fixed connection, the hood must

only be installed by an electrician authorised by the local electricity

board. When installing, an omnipolar disconnector with a distance of

at least 3 mm between contacts must be provided.

Fixed connection of the appliance must only be carried out by an

authorised electrician.

Installation - Fig. 8

Only 5708 D: this model is equipped with two outlet hole. 2 hoses are

therefore necessary for discharging the fumes.

If present, an opening for the easy passage of both hoses must be

made in the top of the wall-unit.

• Drill the base of the wall unit to allow for passage of the hood body.

Fig. 7.

• Drill the top of the wall unit to allow for passage of the exhaust pipe

and the electrical cable. Fig. 7.

• Remove the grease filter (1).

• Remove the grease filter support frame, by pressing the two spring

clamps located at the sides of the frame (2).

• Through the top of the wall unit, insert a pipe with a diameter of

120mm at the connection ring (3).

• Fit the connection ring on the hood exhaust outlet (4) and fasten it

to the exhaust pipe.

• Insert the body of the hood into the hole in the base of the wall unit

(5) – check the position of the exhaust pipe and the electrical cable,

press firmly so that the anchor springs (6) engage above the bottom

of wall unit. Tighten the screws in the anchor springs firmly.

• If necessary the hood can be fastened with four more screws (7).

• Replace the grease filter support frame.

• Replace the grease filter.