A-Neuvideo EP-132 Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Medienkonverter A-Neuvideo EP-132 herunter. A-Neuvideo EP-132 20 Seiten. Serial to ethernet converter

Seite drucken

NEUVIDEO

RIGHT SIDE

LED INDICATORS

Terminator & Reset button

Reset Button

Press the button then turn on the power and wait for 3

seconds. Converter will reset to factory default.

Terminator

There terminator resistor is built-in. If switch 1 & 2 are

set in "ON" position, 120 Ohm resistor will be connected

between the signals.

Converter Description

RS-232

RS-422 / 485

SyS "Red lED":

Power indicated (When power on, LED will flash each time in

one second.)

Rx "green lED":

Network signal receiving indicated (When receive any signal

form network LED will flash.)

Tx "Red lED":

Network signal transforming indicated (When transmit any signal

to network LED will flash.)

lAN "lED":

On-line indicated (When converter link to LAN then the LED will keep

on.) 100M- Green LED/10M- Red LED

TERMINATOR

RESET BUTTON

Serial Port of RS-232/RS-422/RS-485

Connect serial data cable between the converter and

serial device. Follow the setup procedure to configure

the parameters of the converter. (See the following

chapters)