ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Zubehör ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit herunter. ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit 8 Seiten.

Seite drucken

1. Parts List

SETUP AND USE

WARNING

It is required that at least three people initially set up

this Tripod.

1. Find a suitable area to setup the Tripod. Check the ground under the tripod to make sure it is firm and level. Sloping ground

or an uneven surface (one leg section on a rock for example) can cause your tripod to tilt or shift as you climb.

2. Tilt the stand upright by walking the legs upright from the platform down to the end of the legs. Have a third and fourth

person secure the top leg once it is low enough to reach. NOTE: The stand will be platform / top heavy.

3. Once it is standing upright, insert a stake (supplied with the Tripod Top, PN 81518) through the oval shaped hole at the

bottom of each leg as shown in figure 20.

4. Push or hammer each spike completely into the ground at angle as shown in figure 21.

5. Repeat for the other two stakes.

WARNING

Always use the supplied stakes to secure this tripod

to the ground before use - EVEN IF THE TRIPOD WILL

BE USED WITHOUT A LEG EXTENSION KIT. Failure to

secure the tripod may result in instability.

Always maintain three points of contact when

climbing the ladder portion of this tripod stand.

Stakes must be driven completely into the ground at

an angle toward the center of the tripod as shown in

figure 20 and 21.

STAKE

(PN 14060.1200)

WARNING

Angle

STAKE

(PN 14060.1200)

PG 7