ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit Podręcznik - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik dla Akcesoria ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit. ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit 8 stron.

Drukuj stronę
5

SETUP AND USE

WARNING
!
It is required that at least three people initially set up
this Tripod.
1. Find a suitable area to setup the Tripod. Check the ground under the tripod to make sure it is firm and level. Sloping ground
or an uneven surface (one leg section on a rock for example) can cause your tripod to tilt or shift as you climb.
2. Tilt the stand upright by walking the legs upright from the platform down to the end of the legs. Have a third and fourth
person secure the top leg once it is low enough to reach. NOTE: The stand will be platform / top heavy.
3. Once it is standing upright, insert a stake (supplied with the Tripod Top, PN 81518) through the oval shaped hole at the
bottom of each leg as shown in figure 20.
4. Push or hammer each spike completely into the ground at angle as shown in figure 21.
5. Repeat for the other two stakes.
WARNING
!
Always use the supplied stakes to secure this tripod
to the ground before use - EVEN IF THE TRIPOD WILL
BE USED WITHOUT A LEG EXTENSION KIT. Failure to
secure the tripod may result in instability.
20
Always maintain three points of contact when
climbing the ladder portion of this tripod stand.
Stakes must be driven completely into the ground at
an angle toward the center of the tripod as shown in
figure 20 and 21.
STAKE
21
(PN 14060.1200)
WARNING
!
WARNING
!
Angle
STAKE
(PN 14060.1200)
PG 7