Kohler K-1127 Installationshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationshandbuch für Badewannen Kohler K-1127 herunter. Kohler K-1127 25 Seiten. Acrylic bath
Auch für Kohler K-1127: Installationshandbuch (25 seiten), Handbuch für Installation und Pflege (29 seiten), Handbuch für Installation und Pflege (25 seiten), Roughing-In-Handbuch (4 seiten)

Nail 1/4" (6 mm)

thick furring strips

to the studs.

Stud

Use #6 large-head galvanized

nails to secure the nailing-in

flange to the studs.

5. Secure the Bath to the Stud Framing

Drill a small pilot hole through the nailing–in ﬂange at each stud location. Add shims between the

nailing-in ﬂange and the studs as needed to eliminate any gaps.

Nail 1/4" (6 mm) thick furring strips to the studs to shim out to the edge of the nailing-in ﬂange.

Use #6 large-head galvanized nails or screws to secure the nailing-in ﬂange to the studs.

6. Install the Plumbing

CAUTION: Risk of personal injury. Bath rim-mounted faucets that may be inadvertently used as a

means of support are not appropriate or safe for this installation.

CAUTION: Risk of property damage. Make sure a watertight seal exists on all bath drain connections.

NOTE: Provide access to all plumbing connections to simplify future maintenance.

Connect the trap to the drain according to the drain manufacturer's instructions.

Install the faucet valving according to the faucet manufacturer's instructions. Do not install the

faucet trim at this time.

Open the hot and cold water supplies and check all connections for leaks.

Run water into the bath and check the drain connections for leaks.

Fill the bath to the overﬂow and check for leaks.

1016757-2-C

Drill a small hole through

the nailing-in flange at

each stud.

Kohler Co.