Kohler Command PRO ECV630 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Motor Kohler Command PRO ECV630 herunter. Kohler Command PRO ECV630 21 Seiten. Vertical crankshaft
Auch für Kohler Command PRO ECV630: Benutzerhandbuch (8 seiten)
Seite drucken
Accidental Starts can cause severe injury or death.
Disconnect and ground spark plug leads before servicing.
Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equipment, disable the
engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cable from battery.
Maintenance Schedule
These required maintenance procedures should be performed at the frequency stated in the table below. They
should also be included as part of any seasonal tune-up.
Frequency
Daily or Before
Starting Engine
Every 25 Hours
Every 100 Hours
Weekly or Every 150
Hours
Every 200 Hours
Annually or
Every 300 Hours
Annually or
Every 500 Hours
¹Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
²Have a Kohler Engine Service Dealer perform this service.
Low-profile air cleaner.
3
Heavy-duty air cleaner.
4
Check Oil Level
The importance of checking and maintaining
the proper oil level in the crankcase cannot be
overemphasized. Check oil BEFORE EACH USE as
follows:
1. Make sure the engine is stopped, level, and is cool
so the oil has had time to drain into the sump.
2. Clean the area around and beneath the oil fill cap/
dipstick before removing it. This will help keep
dirt, debris, and other foreign matter out of the
engine. See Figure 3.
WARNING
Maintenance Required
• Check oil level.
• Fill fuel tank.
• Check air cleaner for dirty
•
Check air intake and cooling areas, clean as necessary.
• Clean or replace precleaner (if equipped) clean as necessary.
•
Replace element
(low-profile air cleaner models).
1
• Remove and clean shrouds and cooling areas.
• Change oil. (More frequently under severe conditions).
• Check oil cooler fins, clean as necessary (if equipped).
• Check filter minder.
• Inspect air filter paper element and inlet screen area.
•
Replace fuel filter.
1
• Clean, set gap or replace spark plug, and set gap.
• Change oil filter.
• Replace heavy-duty air cleaner element and check inner element.
• Have starter serviced.
, loose, or damaged parts.
1
4
2
Figure 3. Oil Fill Cap/Dipstick and Oil Fill Tube.
1
1,3
1
4
1
Oil Fill Cap/
Dipstick
Oil Fill
Tube
7