Kohler Englefield Valencia Elite Installationsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Inneneinrichtung Kohler Englefield Valencia Elite herunter. Kohler Englefield Valencia Elite 7 Seiten. Corner sliding 12x9
Auch für Kohler Englefield Valencia Elite: Installationsanleitung Handbuch (15 seiten), Installationsanleitung Handbuch (16 seiten), Installationsanleitung Handbuch (14 seiten), Installationsanleitung Handbuch (7 seiten), Installationsanleitung Handbuch (16 seiten), Installationsanleitung Handbuch (17 seiten)

Seite drucken
Kohler Englefield Valencia Elite Installationsanleitung Handbuch
®
VALENCIA
/ VALENCIA ELITE
3. Fixing the vanity to the wall
(a) Fix the cabinet to the wall using screws (min
10g x 75mm) and *20mm washers. Screw
through the back rail or wall so that they screw
into the nog/s in the wall behind.
*Washers must be used to spread the load.
Size
Floor Mount
600
750
900
1200
4. Vanity top
(a) Unpack the top and check for any damage that
might have occurred in transit. Check and
confirm the fit of your selected tapware.
(b) Apply a continuous bead of silicone (not
supplied) to the top edge of the cabinet sides
and back. Ensure there are no gaps in the
sealant bead. This will ensure the top stays
securely fitted to the cabinet and no water
spillage will find its way into the cabinet.
(c) Place the vanity top onto the cabinet ensuring
that the back is flush against the wall and
there is an even overhang on either side of the
cabinet.
=
1223207-A02-G September 2023
®
Double Drawer Vanity
Number of screws required
Wall Mount
3
5
4
7
4
7
5
9
No silicone on
front edge
=
INSTALLATION INSTRUCTIONS
(d) Wipe off any excess sealant.
5. Waste and tapware
(a) Fit the waste and tapware. Connect the water
supply to the taps and waste pipe to the waste
outlet.
(b) Run hot and cold water and check for leaks.
When satisfied with the results move on to the
next section.
6. Drawer re-installation
(a) To re-install the drawers, extend the runners.
Place a drawer onto the runners and slide back
so that the runner hooks insert into the rear of
the drawer.
(b) Make sure the locator pins line up with the
holes in the bottom of the drawer and press the
drawer down so that the pins slot into place.
Locator pin
Page5
Runner hook
*Mount Screws will
need to unscrewed
before removing the
drawer for latest
runners setup.
englefield.co.nz