Kohler Englefield Valencia Elite Installationsanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Inneneinrichtung Kohler Englefield Valencia Elite herunter. Kohler Englefield Valencia Elite 7 Seiten. Corner sliding 12x9
Auch für Kohler Englefield Valencia Elite: Installationsanleitung Handbuch (15 seiten), Installationsanleitung Handbuch (16 seiten), Installationsanleitung Handbuch (14 seiten), Installationsanleitung Handbuch (7 seiten), Installationsanleitung Handbuch (16 seiten), Installationsanleitung Handbuch (17 seiten)

Seite drucken
Kohler Englefield Valencia Elite Installationsanleitung Handbuch
®
VALENCIA
/ VALENCIA ELITE
(c) For 77296 A-*: Re-install the cabinet door.
Hook the hinges onto the base plates and press
down as shown.
7. Drawer Height Adjustment
(a) Remove the drawer. To tilt the drawer front
forward before adjusting the height of drawer.
(b) Turn anticlockwise on the locator pin spacer to
raise the height of the drawer and turn clockwise
to raise down. Repeat on the other runner.
1223207-A02-G September 2023
®
Double Drawer Vanity
Hook
Runner hook
VALENCIA
INSTALLATION INSTRUCTIONS
Vanity
TM
5 Vanity top
Height Adjustment
(a) Unpack the top and check for any damage that
might have occured in transit. Check and
confirm the fit of your selected tapware.
(b) Apply a continuous bead of silicone (not
supplied) to the top edge of the cabinet sides
and back. Ensure there are no gaps in the
sealant bead. This will ensure the top stays
securely fitted to the cabinet and no water
UP
spillage will find its way into the cabinet.
No silicone on
front edge
Note: All drawers are aligned during assembly.
However further adjustment is often required after
installation.
(c) Place the vanity top onto the cabinet ensuring
Please ensure the cabinet has not been twisted
that the back is flush against the wall and
and installed correctly before adjusting.
there is an even overhang on either side of the
cabinet.
8. Sealing
=
(a) All edges MUST be sealed with an approved
Silicone Sealant.
- Between cabinet and floor
- Bewteen cabinet and wall
- Between upstand and wall
(d) Wipe off any excess sealant.
6 Waste and tapware
(a) Fit the waste and tapware. Connect the water
supply to the taps and waste pipe to the waste
outlet.
(b) Run hot and cold water and check for leaks.
When satisfied with the results move on to the
INSTALLATION COMPLETE
next section.
Page6
7 Dr
Front Sectional
View
(a) T
(b) M
DOWN
8 Se
(a) A
=
englefield.co.nz
P
so
th
ho
dr
Si
- B
- B
- B