Aqua Control SELECT Series 2 Gebrauchsanweisung - Seite 10
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Rasen- und Gartengeräte Aqua Control SELECT Series 2 herunter. Aqua Control SELECT Series 2 19 Seiten. Display aerator
Seite drucken1. Tie the mooring line to the eyebolts on the float.
2. Pull the unit past its final location by a distance at least equal to the depth of the pond at the desired final location.
3. Bring the unit back to the final position. There should be enough slack on the electric cord to allow it to hang straight down without tension on
the unit causing it to tilt the spray pattern.
4. Hold the position of the unit in the water by tying the mooring liness to the mooring stakes on shore.
5. Motor torque causes the unit to try to rotate. Upon startup, watch to make sure the unit cannot rotate more than 1/3 of a turn. If it is allowed to
rotate, the electric cord can pull around the unit very tightly and cause damage.
6. Never allow long lengths of rope to float near the intake of the unit where it can be pulled in and entangled in the propeller or impeller.
MOORING EYE
BOTTOM OF POND
1 0
INSTALLATION
SELECT SERIES
MOORING - FLOATING UNITS
FINAL LOCATION OF UNIT
FLOAT EYEBOLT
Aqua Control, Inc. 60 Hz. Select Series 2 Instruction Manual
2
LAUNCHING
MOORING EYE