Aqua Cooler AC-NNEBFPG Gebrauchs- und Pflegeanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchs- und Pflegeanleitung für Water System Aqua Cooler AC-NNEBFPG herunter. Aqua Cooler AC-NNEBFPG 11 Seiten. Surface mounted bottle filler conversion

Seite drucken
INSTALLATION CONT.
Attach the ¼" union fitting to the Cooling
Tank water line out (Fig 12A).
Attach one end of the provided ¼" water
line with insulation tubing to the solenoid
valve located on the alcove, and the other
end to the ¼" union fitting. Cut provided
water line and insulation tubing as needed.
Your Partner in Cool.
14
Guide the power cord down to the lower
portion of the cooler. Ensure that the power
cord does not become entangled with other
components and ensure that the IEC connector
is firmly installed into the power brick
INSTALLATION CONT.
Install the provided strain relief P-Clip to the power cord roughly 36" from the grounded plug.
Attach it to the back side flange of the fountain frame with a #8 Torx screw. (Figure 14a).
Attach the ring terminal to the ground screw on the left side of the fountain strut through the
lower flared hole using the provided #8 thread cutting hex Screw. (Fig 15a). Do not remove/
alter the original ground.
Finish by plugging in the grounded plug into the duplex socket
15