Aqua Cooler AC-NNEBFPG Manuel d'utilisation et d'entretien - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Aqua Cooler AC-NNEBFPG. Aqua Cooler AC-NNEBFPG 11 pages. Surface mounted bottle filler conversion

Imprimer la page

INSTALLATION CONT.

Attach the ¼" union fitting to the Cooling

Tank water line out (Fig 12A).

Attach one end of the provided ¼" water

line with insulation tubing to the solenoid

valve located on the alcove, and the other

end to the ¼" union fitting. Cut provided

water line and insulation tubing as needed.

Your Partner in Cool.

Guide the power cord down to the lower

portion of the cooler. Ensure that the power

cord does not become entangled with other

components and ensure that the IEC connector

is firmly installed into the power brick

INSTALLATION CONT.

Install the provided strain relief P-Clip to the power cord roughly 36" from the grounded plug.

Attach it to the back side flange of the fountain frame with a #8 Torx screw. (Figure 14a).

Attach the ring terminal to the ground screw on the left side of the fountain strut through the

lower flared hole using the provided #8 thread cutting hex Screw. (Fig 15a). Do not remove/

alter the original ground.

Finish by plugging in the grounded plug into the duplex socket