Dexter Laundry DRC55 Series Gebrauchsanweisung - Seite 4
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trockner Dexter Laundry DRC55 Series herunter. Dexter Laundry DRC55 Series 12 Seiten. Dexter drc55 series dryers (25kg capacity)
Seite drucken
INSTALLATION AND OPERATING INSTRUCTIONS
Note: Before installation, check that the local distribution conditions, nature of gas and
pressure, and the adjustment of the appliance are compatible.
UNCRATING
1. Remove cardboard container and innerpack.
2. Complete the uncrating as described in the procedure listed on the instruction sheet taped to
the loading door glass.
FIELD ASSEMBLY
For secure packaging, the dryer is shipped with the tee, one part of the heat reclaimer, inside the
lower service door.
To install:
STEP 1.
Remove 4 metal screws from the bag in coin box. Go to the rear of the dryer and remove the
tape holding the top of the vertical 8 in. (200 mm) pipe.
STEP 2.
Install the tee into both the vertical pipe and the horizontal boot. Using the four pilot holes
provided, drill 4 matching 9/64 in. (3.6 mm) diameter mounting holes; 2 holes through the boot
into the tee outlet, and 2 holes through the tee inlet into the 8 in. (200 mm) vertical pipe. Install
the 4 screws provided to secure the tee to the pipe and boot.
STEP 3.
Install your exhaust system to the tee. Tape all joints with 2 in. (50 mm) duct tape.
DRYER INSTALLATION
1. CODE CONFORMITY: All commercial dryer installations must conform to the local and
national codes for the location of installation.
2. INSTALLATION CLEARANCES: This unit may be installed at the following alcove
clearance.
I. Left Side
II. Right Side 1 in. (25 mm)*
0 in.
-4-