CPE 50067 Benutzerhandbuch und Betriebsanleitung - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Betriebsanleitung für Werkzeuge CPE 50067 herunter. CPE 50067 13 Seiten. Swivel wall mount metal hose reel
Seite drucken50067
ENGLISH
attaching the Crank Knob
tools Required:
– #3 Phillips screwdriver
instructions:
1 . Place crank knob over its mounting .
2 . Secure in place using washer and screw provided .
Mounting to stucco, Concrete or
brick Masonry Construction
tools Required:
– 10 mm Socket or Wrench
– Powered hand drill or hammer drill with 3/8 in .
(10 mm) masonry drill bit
– Small hammer or mallet
instructions:
1 . Determine the mounting hole locations using the
mounting stencil provided with this manual .
2 . Drill four (4) holes 2 .4 in . (60 mm) deep .
3 . Insert the masonry anchors provided, into each hole .
These may need to be seated by tapping with the
mallet .
4 . Open the locking hinge and lock in a position that
allows access to the mounting brackets .
5 . Locate unit over holes and secure with lag screws
provided .
Mounting to flat Wood frame Construction
tools Required:
– 10 mm Socket or Wrench
– Powered hand drill with 1/4 in . (6 mm) standard drill bit
instructions:
1 . Determine the mounting hole locations using the
mounting stencil provided with this manual .
2 . Drill four (4) holes 2 .4 in . (60 mm) deep .
3 . Open the locking hinge and lock in a position that
allows access to the mounting brackets .
4 . Locate unit over holes and secure with lag screws
provided .
Caution
To prevent damage or injury, be sure to verify that
holes align with stud locations in the wall .
attaching the leader Hose
instructions:
1 . Remove leader hose from the reel .
2 . Verify placement of rubber washers in leader hose
couplings .
3 . Install one end of the leader hose to the water inlet
tightening the threaded coupling by hand .
asseMblY
4
REV 50067-20120516