CPE 50067 Gebruikershandleiding en bedieningsinstructies - Pagina 7
Blader online of download pdf Gebruikershandleiding en bedieningsinstructies voor {categorie_naam} CPE 50067. CPE 50067 13 pagina's. Swivel wall mount metal hose reel
Pagina afdrukken50067
ENGLISH
attaching the Crank Knob
tools Required:
– #3 Phillips screwdriver
instructions:
1 . Place crank knob over its mounting .
2 . Secure in place using washer and screw provided .
Mounting to stucco, Concrete or
brick Masonry Construction
tools Required:
– 10 mm Socket or Wrench
– Powered hand drill or hammer drill with 3/8 in .
(10 mm) masonry drill bit
– Small hammer or mallet
instructions:
1 . Determine the mounting hole locations using the
mounting stencil provided with this manual .
2 . Drill four (4) holes 2 .4 in . (60 mm) deep .
3 . Insert the masonry anchors provided, into each hole .
These may need to be seated by tapping with the
mallet .
4 . Open the locking hinge and lock in a position that
allows access to the mounting brackets .
5 . Locate unit over holes and secure with lag screws
provided .
Mounting to flat Wood frame Construction
tools Required:
– 10 mm Socket or Wrench
– Powered hand drill with 1/4 in . (6 mm) standard drill bit
instructions:
1 . Determine the mounting hole locations using the
mounting stencil provided with this manual .
2 . Drill four (4) holes 2 .4 in . (60 mm) deep .
3 . Open the locking hinge and lock in a position that
allows access to the mounting brackets .
4 . Locate unit over holes and secure with lag screws
provided .
Caution
To prevent damage or injury, be sure to verify that
holes align with stud locations in the wall .
attaching the leader Hose
instructions:
1 . Remove leader hose from the reel .
2 . Verify placement of rubber washers in leader hose
couplings .
3 . Install one end of the leader hose to the water inlet
tightening the threaded coupling by hand .
asseMblY
4
REV 50067-20120516