CPE 50070 Benutzerhandbuch und Betriebsanleitung - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Betriebsanleitung für Werkzeuge CPE 50070 herunter. CPE 50070 10 Seiten. Metal hose reel
Seite drucken
50070
ENGLISH
NOTE
Carefully remove all parts from the packing box .
Locate all hardware and components before
installation .
Mounting on masonry or brick
Tools Required (Not Included):
– Powered hand drill or hammer drill with 13 mm
(1/2 in .) masonry drill bit
– Small hammer or mallet
– 10 mm socket or wrench
Instructions:
1 . Place the hose reel on the mounting surface and
use a pencil to mark the location of the 4 mounting
holes .
2 . Using an electric drill, drill holes with a 13 mm
(1/2 in .) diameter masonry bit no deeper than
4 . 1 cm (1 5/8 in .)
3 . Insert the masonry wall anchors into the anchor
sleeves . Insert the anchor and sleeve together into
the drilled holes on the wall . The anchor sleeve must
be inserted all the way into the wall . These may need
to be seated by tapping with the mallet . Repeat for
all 4 holes . See Diagram below .
4 . Place the reel onto the masonry wall anchors .
5 . Place a flat washer, lock washer and nut on each
masonry wall anchor . Tighten to secure .
Mounting to flat Wood frame Construction
Tools Required (Not Included):
– 10 mm socket or wrench
– Powered hand drill with 6 mm (1/4 in .) standard drill
bit
Instructions:
1 . Place the hose reel on the mounting surface and
use a pencil to mark the location of the 4 mounting
holes .
2 . Using an electric drill, drill pilot holes 6 mm (¼ in .)
in diameter, 5 cm (2 in .) deep .
3 . Place the reel on the wall, aligning the mounting
holes with the pilot holes in the wall . Secure with 4
lag screws provided .
CAUTION
To prevent damage or injury, be sure to verify that
holes align with stud locations in the wall .
NOTE
Mounting on other materials may require other
hardware .
Handle Assembly
Instructions:
1 . Requires two 10 mm wrenches to assemble (not
included) . Place the handle on the hub of the hose
reel and secure with bolt and lock nut .
Attaching the Leader Hose
Instructions:
1 . Verify placement of rubber washers in leader hose
couplings .
2 . Install one end of the leader hose to the water inlet
tightening the threaded coupling by hand .
ASSEMbLY
4