CPE 50070 Panduan Pemilik & Petunjuk Pengoperasian - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pemilik & Petunjuk Pengoperasian untuk Peralatan CPE 50070. CPE 50070 10 halaman. Metal hose reel
Halaman Cetak
50070
ENGLISH
NOTE
Carefully remove all parts from the packing box .
Locate all hardware and components before
installation .
Mounting on masonry or brick
Tools Required (Not Included):
– Powered hand drill or hammer drill with 13 mm
(1/2 in .) masonry drill bit
– Small hammer or mallet
– 10 mm socket or wrench
Instructions:
1 . Place the hose reel on the mounting surface and
use a pencil to mark the location of the 4 mounting
holes .
2 . Using an electric drill, drill holes with a 13 mm
(1/2 in .) diameter masonry bit no deeper than
4 . 1 cm (1 5/8 in .)
3 . Insert the masonry wall anchors into the anchor
sleeves . Insert the anchor and sleeve together into
the drilled holes on the wall . The anchor sleeve must
be inserted all the way into the wall . These may need
to be seated by tapping with the mallet . Repeat for
all 4 holes . See Diagram below .
4 . Place the reel onto the masonry wall anchors .
5 . Place a flat washer, lock washer and nut on each
masonry wall anchor . Tighten to secure .
Mounting to flat Wood frame Construction
Tools Required (Not Included):
– 10 mm socket or wrench
– Powered hand drill with 6 mm (1/4 in .) standard drill
bit
Instructions:
1 . Place the hose reel on the mounting surface and
use a pencil to mark the location of the 4 mounting
holes .
2 . Using an electric drill, drill pilot holes 6 mm (¼ in .)
in diameter, 5 cm (2 in .) deep .
3 . Place the reel on the wall, aligning the mounting
holes with the pilot holes in the wall . Secure with 4
lag screws provided .
CAUTION
To prevent damage or injury, be sure to verify that
holes align with stud locations in the wall .
NOTE
Mounting on other materials may require other
hardware .
Handle Assembly
Instructions:
1 . Requires two 10 mm wrenches to assemble (not
included) . Place the handle on the hub of the hose
reel and secure with bolt and lock nut .
Attaching the Leader Hose
Instructions:
1 . Verify placement of rubber washers in leader hose
couplings .
2 . Install one end of the leader hose to the water inlet
tightening the threaded coupling by hand .
ASSEMbLY
4