CPE 50075 Benutzerhandbuch und Betriebsanleitung - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Betriebsanleitung für Rasen- und Gartengeräte CPE 50075 herunter. CPE 50075 14 Seiten. Garden sink
Seite drucken50075
ENGLISH
CaUTiOn
To prevent injury, always wear proper safety goggles
and safety gear when assembling or installing the
garden sink .
CaUTiOn
To prevent damage or injury, be sure to verify that
holes align with stud locations in the wall .
nOTe
Carefully remove all parts from the packing box .
Locate all hardware and components before
installation .
nOTe
Mounting on other materials than wood, masonry or
brick, may require other hardware .
Wood mounting
Tools required (not included):
– Powered hand drill or hammer drill
– 4 mm (5/32 in .) wood drill bit
– Screwdriver tip bit
– Pencil or marker
instructions:
1 . Using a pencil or marker, locate and mark 4 studs
on the wall .
2 . Using the mounting template provided, try and aline
the holes in the template with the marks for studs .
3 . Mark the 4 needed hole spots for mounting,
indicated on the mounting template .
4 . Using the 4 mm (5/32 in .) wood drill bit, drill pilot
holes into the 4 marked hole spots .
5 . Have an assistant hold the sink frame (#32) up
against the wall, aligning the 4 holes in the frame
with the 4 pilot holes on the wall .
Wood mounting cont'd.
6 . Using a power hand drill or hammer drill with a
screwdriver tip bit, secure a M6x60 wood screw
(#17) into a pilot hole on the wall, through the hole
in the sink frame .
7 . Repeat for the 3 remaining holes .
8 . Tighten all screws but do not overtighten .
9 . Make sure the support frame is secure on the wall
before continuing .
nOTe
If studs can not be found or aligned properly with
the template and frame, the supplied wall anchors
should be used to help secure frame to wall .
Masonry or brick mounting
Tools required (not included):
– Powered hand drill or hammer drill
– 6 mm (15/64 in .) masonry drill bit
– Screwdriver tip bit
– Hammer or mallet
– Pencil or marker
instructions:
1 . Using a pencil or marker and the mounting template
provided, mark 4 spot holes on the wall .
2 . Using the 6 mm (15/64 in .) masonry drill bit, drill
pilot holes into the 4 marked hole spots .
3 . Insert a wall anchor into the pilot hole as far as you
can with your hand .
Side view
4 . Using the hammer or mallet, gently tap the wall
anchor (#18) firmly into the pilot hole .
5 . Repeat for the remaining 3 holes .
6 . Have an assistant hold the sink frame (#32) up
against the wall, aligning the 4 holes in the frame
with the 4 holes in the anchors on the wall .
aSSeMbly
Wall
Anchor
REV 50075-20140319
4