ページを印刷する50075
ENGLISH
CaUTiOn
To prevent injury, always wear proper safety goggles
and safety gear when assembling or installing the
garden sink .
CaUTiOn
To prevent damage or injury, be sure to verify that
holes align with stud locations in the wall .
nOTe
Carefully remove all parts from the packing box .
Locate all hardware and components before
installation .
nOTe
Mounting on other materials than wood, masonry or
brick, may require other hardware .
Wood mounting
Tools required (not included):
– Powered hand drill or hammer drill
– 4 mm (5/32 in .) wood drill bit
– Screwdriver tip bit
– Pencil or marker
instructions:
1 . Using a pencil or marker, locate and mark 4 studs
on the wall .
2 . Using the mounting template provided, try and aline
the holes in the template with the marks for studs .
3 . Mark the 4 needed hole spots for mounting,
indicated on the mounting template .
4 . Using the 4 mm (5/32 in .) wood drill bit, drill pilot
holes into the 4 marked hole spots .
5 . Have an assistant hold the sink frame (#32) up
against the wall, aligning the 4 holes in the frame
with the 4 pilot holes on the wall .
Wood mounting cont'd.
6 . Using a power hand drill or hammer drill with a
screwdriver tip bit, secure a M6x60 wood screw
(#17) into a pilot hole on the wall, through the hole
in the sink frame .
7 . Repeat for the 3 remaining holes .
8 . Tighten all screws but do not overtighten .
9 . Make sure the support frame is secure on the wall
before continuing .
nOTe
If studs can not be found or aligned properly with
the template and frame, the supplied wall anchors
should be used to help secure frame to wall .
Masonry or brick mounting
Tools required (not included):
– Powered hand drill or hammer drill
– 6 mm (15/64 in .) masonry drill bit
– Screwdriver tip bit
– Hammer or mallet
– Pencil or marker
instructions:
1 . Using a pencil or marker and the mounting template
provided, mark 4 spot holes on the wall .
2 . Using the 6 mm (15/64 in .) masonry drill bit, drill
pilot holes into the 4 marked hole spots .
3 . Insert a wall anchor into the pilot hole as far as you
can with your hand .
Side view
4 . Using the hammer or mallet, gently tap the wall
anchor (#18) firmly into the pilot hole .
5 . Repeat for the remaining 3 holes .
6 . Have an assistant hold the sink frame (#32) up
against the wall, aligning the 4 holes in the frame
with the 4 holes in the anchors on the wall .
aSSeMbly
Wall
Anchor
REV 50075-20140319
4