Dell Inspiron 1420 Service-Handbuch - Seite 29

Blättern Sie online oder laden Sie pdf Service-Handbuch für Laptop Dell Inspiron 1420 herunter. Dell Inspiron 1420 46 Seiten. Service manual
Auch für Dell Inspiron 1420: Setup-Handbuch (2 seiten), Einrichten (2 seiten), Service-Handbuch (46 seiten)

Seite drucken
Dell Inspiron 1420 Service-Handbuch
Back to Contents Page
  Memory
Dell™ Inspiron™ 1420/Dell Vostro™ 1400 
Service Manual
  Removing the Memory Module
  Replacing the Memory Module
You can increase your computer memory by installing memory modules on the system board. Install only memory modules that are intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets, DIMM A and DIMM B accessed from the bottom of the computer.
 
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMMA" before you install
a module in the connector labeled "DIMMB." Insert memory modules at a 30-degree angle to avoid damaging the connector.
NOTE:
For optimal performance, identical memory modules should be used in each connector.
NOTE:
If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
 Removing the Memory Module
 
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
 
1. Follow the procedures in
Before You
 
2. Turn the computer over.
 
3. Loosen the captive screws from the memory module cover.
 
4. Lift the memory module cover and set it aside.
1
captive screws (3)
 
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
 
5. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
 
6. Remove the module from the connector.
Begin.
2
memory module cover