Dell Inspiron 1420 Manual de servicio - Página 29

Navegue en línea o descargue pdf Manual de servicio para Portátil Dell Inspiron 1420. Dell Inspiron 1420 46 páginas. Service manual
También para Dell Inspiron 1420: Manual de instalación (2 páginas), Puesta en marcha (2 páginas), Manual de servicio (46 páginas)

Imprimir página

Back to Contents Page

Memory

Dell™ Inspiron™ 1420/Dell Vostro™ 1400

Service Manual

Removing the Memory Module

Replacing the Memory Module

You can increase your computer memory by installing memory modules on the system board. Install only memory modules that are intended for your computer.

NOTE:

Memory modules purchased from Dell are covered under your computer warranty.

Your computer has two user-accessible SODIMM sockets, DIMM A and DIMM B accessed from the bottom of the computer.

NOTICE:

If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMMA" before you install

a module in the connector labeled "DIMMB." Insert memory modules at a 30-degree angle to avoid damaging the connector.

NOTE:

For optimal performance, identical memory modules should be used in each connector.

NOTE:

If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

Removing the Memory Module

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface

(such as a connector on the back of the computer).

1. Follow the procedures in

Before You

2. Turn the computer over.

3. Loosen the captive screws from the memory module cover.

4. Lift the memory module cover and set it aside.

captive screws (3)

NOTICE:

To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.

5. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

6. Remove the module from the connector.

Begin.

memory module cover