Avtech AVM311 Kurzanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Kurzanleitung für IP-Kamera Avtech AVM311 herunter. Avtech AVM311 6 Seiten.

 Installation (Continued)

Step 5: Be sure to replace the original desiccant(s) with the new ones. Use

provided double-sided tape to stick the desiccants in place as

illustrated below. Keep them inward enough for the housing to close

nicely. The new desiccants must not be exposed to air for over 30

seconds.

Note: Both the two new desiccants are to be put in the camera to

remove excessive humidity and ensure the camera works well.

Step 6: Then, clear the lens of fingerprints and replace the housing before

tightening the screws on it.

Step 7: Power up the camera.

 Camera Configuration

For advanced configuration of your camera, please be sure you have

connected your camera to NVR as shown below:

 Focusing the Camera

If you need to adjust the focus, the picture below

shows you how:

Step1: Connect PC to the HUB connected to your camera(s) with RJ45 network cable.

Step2: Search available devices with "IPScan.exe"; to download "IPScan.exe", please visit

www.surveillance-download.com/user/IPscan.zip

Step3: After searching, set your PC in the same network segment as the specific camera you want to access, such as

"192.168.30.xxx" (xxx could be 0~255) in our example

Step4: Note down the IP address and port number of the camera you want to access, such as "192.168.30.1" and "88" in our

example.

Step5: Open Internet Explorer on the PC, and enter the IP address and port number in the URL column to access the

camera. The format is http://ipaddress:portnum, such as http://192.168.30.1:88 in our example.

 Inserting MicroSD Card

The data originally saved in the microSD card (if any) will be removed

after inserting it to the camera.

The camera doesn't support hot-swapping. Please insert or remove

the microSD card with power disconnected.

Please follow the directions in the below graphic to insert MicroSD card

properly: