Allied Telesis AR400 Series So konfigurieren Sie - Seite 2

Blättern Sie online oder laden Sie pdf So konfigurieren Sie für Netzwerk-Hardware Allied Telesis AR400 Series herunter. Allied Telesis AR400 Series 6 Seiten. How to set up pppoe between a linux client and access concentrator
Auch für Allied Telesis AR400 Series: Handbuch zur Fehlersuche (8 seiten), Fehlersuche (5 seiten), Handbuch zur Schnellinstallation (8 seiten), Handbuch zur Schnellinstallation (12 seiten), Handbuch mit Sicherheitsinformationen (18 seiten), Anleitungen (8 seiten)

Related How To Notes

You may also find the following How To Notes useful:

How To Configure Remote L2TP Tunnels

How To Configure Allied Telesis and Cisco Routers To Interoperate Over L2TP

How To Notes are available from www.alliedtelesis.com/resources/literature/howto.aspx.

An example scenario for RIP over L2TP

Our example uses two office sites that are connected via a WAN connection over the

Internet using an L2TP tunnel for security.

The setup (shown below) shows the 'Central office' and 'Remote office' routers connected,

in this case, back to back via their Ethernet interfaces (this would likely be the remote WAN

connection across the Internet, with perhaps static IP assignment from the ISPs).

Page 2 | AlliedWare™ OS How To Note: Dynamic Routing over L2TP

Central office router

192.168.1.1

RIP propogates

VLAN OSPF

PPP0 over

routes over

L2TP tunnel

to remote router

192.168.2.1

Remote office router

VLAN 2 IP=222.222.2.1

OSPF used on

local VLAN

networks

ETH0

X PC

HUB

POWER

Eth0 IP=10.10.10.1

WAN

Eth0 IP=10.10.10.2

X PC

HUB

POWER

ETH0

OSPF used on

local VLAN

networks

VLAN 2 IP=200.200.2.1

An example scenario for RIP over L2TP

VLAN 1 IP=222.222.1.1

VLAN 1 IP=200.200.1.1

rip-l2tp.eps